Another problem with DN105

You are here: Home > Forum > Simulations > Released > Edge Hill > Another problem with DN105

Page 1 of 1

Another problem with DN105 29/05/2016 at 22:29 #82733
grahamj42
Avatar
130 posts
4L95 was passing through Ditton Reception Sidings while 4M56 was waiting at DN105.

When TDNDEJ cleared, DN821 went back to red and the route DN821 -> DN8007 was held by occupation of TDNDEK and TDNDEU.

I pre-set the route DN105 -> DN801. DN105 cleared immediately to yellow (no overlap, but it's a goods line so perhaps OK).

When TDNDEK clears, the route DN821-DN8007 is released and DN105 is put back to red.

Now I've written this, I see what the problem is.

There is a condition on DN105 -> DN821 that DN105 will not clear unless there is a route set from DN821 (DN821, being approach controlled, remains at red), but this condition doesn't distinguish between a route set and a route held (after a train has passed).

This occurred with TORR on. I suppose with TORR off, DN105 would not be put back unless I released the route DN821 -> DN8007 before 4M56 passed DN821.

Log in to reply