Upcoming Games

No games to display

Full list
Add a game

Upcoming Events

No events to display

Stainforth East Ground Frame

You are here: Home > Forum > Simulations > Released > Doncaster (North) > Stainforth East Ground Frame

Page 1 of 1

Doncaster North SX 2015-04-08 09/12/2021 at 11:53 #142832
bugsy
Avatar
1677 posts
Playing this excellent timetable with TORR off and find it much more enjoyable than with TORR on.

I have a minor problem. I have tried to release 0A49 from the Bunker Line at Hatfield Colliery but it would appear that I have either done something wrong or am not doing what I should be doing.
The Ground Frame has been released and I have pulled points lever 2. From here on I am confused because with points lever 4 in either position I can’t set a route from signal 3 without being told that ”Point(s) locked normal by another route”
Which point(s) are these? I can’t see it ☹

I have attached a save which is at the point described above

Any help/advice would be appreciated.

Post has attachments. Log in to view them.
Everything that you make will be useful - providing it's made of chocolate.
Last edited: 09/12/2021 at 19:44 by headshot119
Reason: Moved to a new thread

Log in to reply
Doncaster North SX 2015-04-08 09/12/2021 at 13:26 #142834
bill_gensheet
Avatar
1309 posts
Could not replicate this from your save.

Set 1112 -> 644
Pull 3
Signal 1112 clears and 0A49 comes out OK

Lever 3 does not move until the panel has set 1112 to 644, but I did not get any messages about 'Points locked .......'

Bill

Last edited: 09/12/2021 at 19:45 by headshot119
Reason: Moved to a new thread

Log in to reply
Doncaster North SX 2015-04-08 09/12/2021 at 14:09 #142835
bugsy
Avatar
1677 posts
Thanks Bill. I shall give that a try
Everything that you make will be useful - providing it's made of chocolate.
Last edited: 09/12/2021 at 19:45 by headshot119
Reason: Moved to a new thread

Log in to reply
Doncaster North SX 2015-04-08 09/12/2021 at 14:45 #142837
bugsy
Avatar
1677 posts
bill_gensheet in post 142834 said:
Could not replicate this from your save.

Set 1112 -> 644
Pull 3
Signal 1112 clears and 0A49 comes out OK

Lever 3 does not move until the panel has set 1112 to 644, but I did not get any messages about 'Points locked .......'

Bill
Found what I was doing wrong. I was trying to set the route from 112 to 644 before setting the points lever 2.

Everything that you make will be useful - providing it's made of chocolate.
Last edited: 09/12/2021 at 19:45 by headshot119
Reason: Moved to a new thread

Log in to reply