Wardley entry point!!

You are here: Home > Forum > Simulations > Released > Tyneside IECC > Wardley entry point!!

Page 1 of 1

Wardley entry point!! 29/09/2016 at 20:21 #85505
Giantray
Avatar
330 posts
Has anyone tried to get a train to enter at Wardley?

I have added several freight trains to enter at Wardley and to go into Wardley. Getting into Wardley is fine no problems. However, coming out of Wardley, the train appears, moves forward at 40 mph then reverses and goes back towards Wardley at 15 mph and exits the sim.

There is obviously an error here as the timetables I have compiled have been validated and show Pelaw jn as the next passing point after Wardley.

Retired Professional Railwayman (1981-2023); Pway & S&T (1981-88); Former Signalman/Signaller/ Signalling Trainer (1989-2023) [AB, TCB, Mechanical, NX, WestCad, Hitachi SARS]; Railway Historian (esp.SER, LCDR); Member of The Permanent Way Institution..
Log in to reply
Wardley entry point!! 29/09/2016 at 21:52 #85508
MarkC
Avatar
1084 posts
Giantray in post 85505 said:
Has anyone tried to get a train to enter at Wardley?

I have added several freight trains to enter at Wardley and to go into Wardley. Getting into Wardley is fine no problems. However, coming out of Wardley, the train appears, moves forward at 40 mph then reverses and goes back towards Wardley at 15 mph and exits the sim.

There is obviously an error here as the timetables I have compiled have been validated and show Pelaw jn as the next passing point after Wardley.
I have been playing about with this and for trains to continue pass Pelaw jn you need to have "pass" ticked and not have the train stop at signal "9". And the path "LL"

For some reason stopping the train at sig "9" causes the train to reverse back up along the DN line back towards Wardley.

Last edited: 29/09/2016 at 22:25 by MarkC
Reason: edited

Log in to reply
The following user said thank you: Giantray