Train stuck at '0mph'/'1mph' at E745 after SPAD at E1

You are here: Home > Forum > Simulations > Released > Exeter > Train stuck at '0mph'/'1mph' at E745 after SPAD at E1

Page 1 of 1

Train stuck at '0mph'/'1mph' at E745 after SPAD at E1 22/08/2019 at 00:07 #120166
Albert
Avatar
1313 posts
Hi,

In the attached save in the pre-'86 era, there is a TCF at Totnes so I told train 0B50 to examine the line and pass E1 at danger with a route set towards the platform.

The train is stuck at an intermittent 0mph/1mph in the section between E745X and E745. On reversing, it came to a stand at stop board E745X within seconds. Reversing again brought it into the same 0mph/1mph sequence.

Albert

Post has attachments. Log in to view them.
AJP in games
Log in to reply
Train stuck at '0mph'/'1mph' at E745 after SPAD at E1 22/08/2019 at 01:25 #120167
Hap
Avatar
972 posts
Mantis 26844.

Albert, have you checked for updates for your loader recently?

Craig

How to report an issue: www.SimSig.co.uk/Wiki/Show?page=usertrack:reportanissue
Log in to reply
Train stuck at '0mph'/'1mph' at E745 after SPAD at E1 22/08/2019 at 10:53 #120170
Albert
Avatar
1313 posts
I was continuing a game from before the holidays once I finished that, I'll update my Loader and try to reproduce this on the new one.
AJP in games
Log in to reply
Train stuck at '0mph'/'1mph' at E745 after SPAD at E1 22/08/2019 at 10:55 #120171
Albert
Avatar
1313 posts
I just reloaded the save, cancelled the route from E1 and now the train suddenly continues.
AJP in games
Log in to reply