Glyne

You are here: Home > Forum > Simulations > Released > East Coastway > Glyne

Page 1 of 1

Glyne 05/04/2020 at 21:37 #125411
TylerE
Avatar
149 posts
How the heck do you clear LW42 at Glyne? Can't seem to find any valid routes from this signal.
Log in to reply
Glyne 05/04/2020 at 21:54 #125412
Steamer
Avatar
3913 posts
Online
Use the 'Beddingham Non-Stop' or 'Beddingham Stop' controls located on Berwick's panel, depending on whether or not the approaching train stops at Glynde.

The controls activate different strike-in points (which start the lowering sequence) for Beddingham AHB. A closer strike-in point is used for stopping trains, under the protection of LW42, to avoid excessive delay to road users. For non-stop trains, the strike-in point is further away, as they'll be approaching the crossing at line speed.

Similar controls exist at Normans Bay for Pevensey Sluice AHB.

"Don't stress/ relax/ let life roll off your backs./ Except for death and paying taxes/ everything in life.../ is only for now." (Avenue Q)
Last edited: 05/04/2020 at 21:58 by Steamer
Reason: None given

Log in to reply
Glyne 05/04/2020 at 22:59 #125414
DriverCurran
Avatar
682 posts
Online
As a possible 'interesting side note' the signalman at Berwick was responsible for the stop / non stop control switch for a crossing that was supervised by Lewes....

Paul

You have to get a red before you can get any other colour
Log in to reply