Upcoming Games


Full list
Add a game

Issue with TM71

You are here: Home > Forum > Simulations > Australian Sims > Moss Vale NSW > Issue with TM71

Page 1 of 1

Issue with TM71 05/05/2020 at 14:30 #126558
randomkid9600
Avatar
1 posts
Hi

I seem to be having an issue with TM71 and I was wondering if anyone else has had this issue and found a way to fix it.

When TM71 arrives at north fork moss vale it changes direction and shunts back towards Calwalla, once it gets to signal 34.6 it stops and I cant get it to do anything after that.

All I have been able to do with it is Remove train.

As you can see with the attached photo the road was set and it got to north fork but didn't go any further.


Any advice or help would be greatly appreciated

Post has attachments. Log in to view them.
Last edited: 05/05/2020 at 14:31 by randomkid9600
Reason: More Details

Log in to reply
Issue with TM71 06/05/2020 at 06:13 #126572
Airvan00
Avatar
112 posts
randomkid9600 in post 126558 said:
Hi

I seem to be having an issue with TM71 and I was wondering if anyone else has had this issue and found a way to fix it.

When TM71 arrives at north fork moss vale it changes direction and shunts back towards Calwalla, once it gets to signal 34.6 it stops and I cant get it to do anything after that.

All I have been able to do with it is Remove train.

As you can see with the attached photo the road was set and it got to north fork but didn't go any further.


Any advice or help would be greatly appreciated
Yes, I had the same problem. As you observed, at Moss Vale NTh Fork (signal MV28) the train changes from a down train (down Illawarra) to an up train (up main) if it stops at MV28 it will behave as you describe however if you change the halt to just a passing time the train and hold the train at mv21 until it can be given a clear run (behind SN34) it will not reverse will continue onto the up main. Bear in mind that this sim was released as a pre release version and contains lots of bugs (including the time table) and we are patiently waiting for the corrected version to be released.

Log in to reply
The following user said thank you: randomkid9600