Cannot set route from signal 90 to 82

You are here: Home > Forum > Simulations > Released > Liverpool Street > Cannot set route from signal 90 to 82

Page 1 of 1

Cannot set route from signal 90 to 82 07/08/2013 at 14:08 #48069
CTCThiago
Avatar
232 posts
Good Evening,

I'm simulating the new Liverpool St (Simsig loader), and i went to test the "Incident Control Panel" (F11), until here alright, i close the Up Main (Bow Jn), the following track circuits [TFU-TFV-TFW-TFX], and i close, Up and Down Suburban, [TAP-TAR] for the Down, and [TBW] for the Up. Trains coming from Suburban lines will stop or pass Bethnal Green station, then will diverge to the Down Main Line (Up Main closed) towards signal 82 (controlled signal) then diverge back to the Up suburban towards signal 70 (semi-automatic signal w/ banner). On the test i cannot set the route from signal 90 to 82 (Up Suburban to Down Main), but i can set the route from 82 to 70 (Down Main to Up Suburban). I think to myself, the signal 90 don't have the relays to communicate with signal 82, i could be wrong, the signal 90 only have the relays to communicate with signals 80 (Up suburbun ahead) and 84 (Up main), I think the only person can clarify this question for me, is the developer (Geoff), but i think you guys has experienced the same problem, if yes, post a reply down here to discuss the subject.

Thanks in advance,
Cheers,
CTC.

Log in to reply
Cannot set route from signal 90 to 82 07/08/2013 at 16:12 #48075
Hpotter
Avatar
205 posts
This is correct as L90 can be routed to L80 (Up Suburban) and L84 (Up Main) only.
The only routes to L82 are from L92 (Up Main) and L94 (Up Electric)

This is as per real life.
(Hope that this helps?)

Log in to reply
The following users said thank you: CTCThiago, GeoffM
Cannot set route from signal 90 to 82 07/08/2013 at 16:48 #48079
CTCThiago
Avatar
232 posts
this was very helpful HPotter, thanks to clarify.

:cheer:

Log in to reply