Page 1 of 1
| Coded manual operation ignored? 16/11/2013 at 22:57 #51624 | |
UKTrainMan
1803 posts |
After an initial foray into this simulation by playing the Saturday Engineering timetable to allow me to get to grips with the whole simulation, I've finally decided to give a full timetable a go - selecting the Sunday timetable to start me off. Within 20 minutes I suddenly notice the F7 Incident Report button flashing (but surprisingly no actual message event warning me of this(?); much like with a Points, Signal, or Track Circuit Failure?!!), and the message I get is "06:57:07 Coded Manual operation between Victoria and Green Park Northbound". Brief panic ensues as I try to recall what this means, and eventually resort to the manual to check. 22mph running, great. The first train due this way is V201-1 from Brixton. As this train departs Victoria, I decide to watch it via F2 Train List, yet notice it seemingly happily going along at 36-37mph?!! :blink: Any views and / or opinions expressed by myself are from me personally and do not represent those of any company I either work for or am a consultant for. Log in to reply |
| Coded manual operation ignored? 16/11/2013 at 23:16 #51625 | |
Peter Bennet
5360 posts |
Yes I saw a previous report but have not had time to investigate fully. Peter I identify as half man half biscuit - crumbs! Log in to reply |
| Coded manual operation ignored? 16/11/2013 at 23:21 #51626 | |
|
UKTrainMan
1803 posts |
" said:Yes I saw a previous report but have not had time to investigate fully.Possibly Possible Bug - Coded Manual Operation not Saving? Was thinking of posting this in that thread, but originally decided against as probably felt were different matters. Any views and / or opinions expressed by myself are from me personally and do not represent those of any company I either work for or am a consultant for. Log in to reply |
| Coded manual operation ignored? 18/11/2013 at 20:44 #51707 | |
|
UKTrainMan
1803 posts |
Found a sort-of work-around to kind-of keep this particular type of failure somewhat realistic. Upon receiving notification of this via F7 - Incident Report, open up F11 - Incident Control Panel and use the TSRs (Temporary Speed Restrictions) tab to apply TSRs for all of the associated TCs. :evil: After you are informed Coded Manual Operation is now lifted, simply open up F11 - Incident Control Panel again and delete the TSRs. For those wondering, my first 'run in' with CMO lasted for 1hr and 46mins, however didn't seem to cause too much of a delay (probably 1 minute at most). Any views and / or opinions expressed by myself are from me personally and do not represent those of any company I either work for or am a consultant for. Last edited: 18/11/2013 at 20:55 by UKTrainMan Log in to reply |