Signal 244 clearing before route set

You are here: Home > Forum > Simulations > Australian Sims > Strathfield NSW > Signal 244 clearing before route set

Page 1 of 1

Signal 244 clearing before route set 02/08/2018 at 20:45 #110694
Forest Pines
Avatar
515 posts
I have noticed when setting a route from 244 to 240, that 244 appears to change to a proceed aspect a little bit before the points are fully over - the points keep flashing for a second or two after the signal clears (to YY, naturally).
Log in to reply
Signal 244 clearing before route set 03/08/2018 at 01:17 #110700
flabberdacks
Avatar
253 posts
Thanks for noting this. It's a known issue relating to the way points operate in sequence for route 244 to 240. A ticket is already open for its fixing.
Log in to reply
The following user said thank you: Forest Pines
Signal 244 clearing before route set 02/04/2019 at 09:27 #117141
Hawk777
Avatar
308 posts
Not sure if the ticket covers this, but it’s not just a matter of the order in which things appear to happen, it’s actually a wrong-side failure. If you fail reverse detection on points 602 and call route 244 to 240, 244 will clear, and remain clear, despite the points never proving at all. A train can then be brought up to 244, in which case it will pass it without complaint and proceed to 238 (assuming points are stuck normal, e.g. hand cranked), despite the route appearing to be set to 240.
Log in to reply
Signal 244 clearing before route set 20/07/2019 at 01:35 #119519
flabberdacks
Avatar
253 posts
Yep, we know about it. Will be patched in the next update. Thanks!
Log in to reply