Belper GF Help

You are here: Home > Forum > Simulations > Released > Derby > Belper GF Help

Page 1 of 1

Belper GF Help 21/04/2023 at 11:26 #151341
ajax103
Avatar
1106 posts 		How do you set a route in and out of the siding at this location?

I've looked on the manual which says "Belper Ground Frame
There are two releases for this frame. Moves between the Up Main and the siding do not require the Down Main release, moves between the Down and Up Main require both releases."

It doesn't actually say in which order do you set the route to or from the siding if for example reversing from the Sheffield direction.

Have tried a dozen times and each time it's simply not possible as the route that is needed simply doesn't happen.
Log in to reply
Belper GF Help 21/04/2023 at 11:59 #151343
Hap
Avatar
986 posts
Online 		ajax103 in post 151341 said:
How do you set a route in and out of the siding at this location?

I've looked on the manual which says "Belper Ground Frame
There are two releases for this frame. Moves between the Up Main and the siding do not require the Down Main release, moves between the Down and Up Main require both releases."

It doesn't actually say in which order do you set the route to or from the siding if for example reversing from the Sheffield direction.

Have tried a dozen times and each time it's simply not possible as the route that is needed simply doesn't happen.
You need to free the UM frame, (DY961), then throw the points 2A/2B, then pull the signal off Up Main (BPUM).
Post has attachments. Log in to view them.
How to report an issue: www.SimSig.co.uk/Wiki/Show?page=usertrack:reportanissue
Last edited: 21/04/2023 at 11:59 by Hap
Reason: None given
Log in to reply
The following user said thank you: ajax103
Back