Dean Hill GF

I've got a train waiting to enter the siding and the GF is free. I have the GF menu open, with the king lever pulled. When I pull the points lever, the lever moves, but the points do not move. I can pull the UP GPL signal lever, which turns the stem white, but doesn't clear the signal. Tried on 80's and 2000 eras. 3016 Main can also be checked, which goes yellow, but the route that goes white are the track circuits beside 5 and 7.

Dean Hill GF
The GF requires the emergency replacement switches on signals 1 and 5 to be operated. There is a 120s delay between granting the release and being able to operate the frame.

The switch on signal 5 should be operated as soon as a train for the sidings enters the simulation. When the train stops at signal 5, operate the replacement on signal 1 and release the frame. After 120s, click the 'signal 5' tick box, which will clear the subsidiary on signal 5 and allow the train to proceed over the AHB. The points can then be operated, along with lever 2.

Trains exiting the siding must be signalled using the 'Siding Main Signal' tick box, which will clear the signal at the exit of the sidings. The 'Siding Shunt Signal' is used only for movements into the headshunt, i.e. with the points in the normal position.