Page 1 of 1
| Paignton DVR 07/05/2025 at 14:28 #160992 | |
Tomiexpress
39 posts 
|
Train from Paignton DVR not enter , not sure why...
Post has attachments. Log in to view them. Log in to reply |
| Paignton DVR Today at 11:55 #160998 | |
ajax103
1139 posts |
Tomiexpress in post 160992 said:Train from Paignton DVR not enter , not sure why...Basically as the line is only single track I believe, you had 1K01 blocking the DVR route at the Paignton end. You should have got a phone call from the DVR stating that 1P0X is entering area, is this okay? than at the hand over point you ought to have got another phone call from the DVR actually offering you said train. I just did a brief few minutes of the first save and I accepted both calls but upon noticing that the 1K01 didn't seem to be moving, I used the hand of God to edit said timetable to remove train, immediately afterwards, 1P01 appeared like magic. I think the reason why 1K01 was still at the Paignton end was simply because you had not at that point rang up the DVR signaller to offer them the train. That said, when I did offer them 1K01 the DVR signaller accepted the train but the train list just showed 1K01 as stood at the signal with no effort made to go so with that I told the driver to pass the signal at caution and lo and behold 1K01 decided to shift itself. I don't know if it's a bug or not but when I ran the save with only the DVT trains in it, at no point did I get a phone call from the DVR nor was I expected to call them to offer them the return working and yes I did look at the manual too which only says you have to give the DVR a call before sending them a train but it doesn't seem to explain if that only applies to trains running on DVR metals only or just to any train using the national rail connection? Log in to reply |
| Paignton DVR Today at 14:50 #160999 | |
|
Tomiexpress
39 posts
|
DVR rang "I have train 1Z28 to transfer over to you" I gave permission and set the road, it did not enter and from time to time I received further messages "I have train 1Z28 to transfer over to you", it did not appear in F2 either. 1k01 appeared which "got stuck" under QP and did not move even when the road "straight ahead" was laid, probably because I gave permission to enter to me a moment earlier 1. DVR calls "I have train 1Z28 to transfer over to you" 2. I give permission "ok" 3. 1k01 appears which gets stuck 4. regardless of whether I delay laying the road for 1z28 or lay it immediately, 1k01 stands and z1z28 does not enter and is not visible in F2 I tried several approaches but it didn't work, I didn't try to push 1k01 manually quick test , push 1k01 manualy ( pass at danger ) unblock the line beetwen DVR and quuens park, many trains pass, DVR signaler offer train again but 1z28 never arrive Last edited: Today at 15:28 by Tomiexpress Reason: None given Log in to reply |