You are here: Wiki > start > usertrack > ssterms > lineblock

Table of Contents

Line Blocking

Line Blocking

Some simulations, normally where there is an alternative entry point i.e. 4 track main line, can be set to allow lines to be blocked for train entry. This is in addition to any pre-coded closure scenarios.

There are several ways the developer can set these up to work and you will be advised in the manual which has been adopted. These options are:

  • The train is cancelled and will never run
  • Trains are delayed until the block is removed
  • The train will be rerouted to an alternative entry point

The blockage is effected by entering a special TD in the appropriate signal berth.

The following codes can be inserted as TD:

  • BLOK
  • SHUT
  • POSS
  • *T (and any other 2 characters, eg *T3*)

Last edited by GeoffM on 15/09/2016 at 03:00